Distemper White

Limfarve Engelsk

Distemper white is a simple and aqueous product that does not contain dangerous solvents, and it is therefore quite safe to paint with. It appears full matt, solid white and with a textured whitewashed look. Surfaces painted with distemper white reflect light in a beautiful, soft and velvety way because the color pigments are out in the surface. In addition, the distemper color's completely water-open character (Diffusion open), which ensures the best possible moisture balance in walls and ceilings - and thus a better indoor climate.

Application

Distember can be used for walls and ceilings, but the substrate must be light to moderately absorbent, such as plaster, plasterboard, glass fabric, wallpaper and untreated wood. All in all, on an even and uniform absorbent and smooth surface. If in doubt about the sustainability of the substrate, try wetting the surface with water and see if it pulls / sucks into the substrate.

Preparation

The distemper is stirred up with water 1: 1. Pour the right amount of water into the bucket and add the dry mixture little by little while stirring until a lump-free consistency is achieved.

The distemper should preferably stand for 24 hours and draw, and then be stirred again before it is applied.

3000g of glue paint is added to 6500g liters of water. (gives 8 liters of finished paint)

1500g of glue paint is added to 3250g liters of water. (gives 4 liters of finished paint)

You can pre-moisten the wall / ceiling with water before applying the distemper. Completely raw walls can also be primed with a boneglue primer solution or a soap solution.

Application

Apply with a good wide flat brush. The layers must be applied evenly - neither too thin nor too thick. If the distemper is made of a strong color pigment it requires some practice to for a uniform expression. The glue paint dries up quickly, so you have to paint wet in wet and from edge to edge, corner to corner without breaks in the work.

Paint in long uniform strokes, and without too much paint on the brush at a time, the paint should sit in the "" tip "of the brush so you get the best result. Always finish with long strokes from the bottom up (walls), on ceilings painted against the light from the windows.

Distemper is not suitable for rooms and surfaces where there can be a lot of wear, eg hallways, children's rooms, over kitchen tables, stoves and the like. since it does not have a strong durable surface.

Distemper can be washed down with cold water and sponge if you want to apply a new paint, for example, or you want a different look on the wall or ceiling.

Colors

Adhesive color can be tinted in light and medium colors with color pigment if desired (The pigments are soaked in water to a paste, and then stirred into the paint), but the darker the color, the greater the possibility that it can spread. Make evt. a sample coat to tone you down on the color, and to sense how much color pigment the paint can "wear".

Coverage

Approx. 6-8m2 per liter, The adhesive color Apply in 1-2 layers, depending on the nature of the substrate.

Drying time 

Approx. 2 hours

Contents

Chalk, Titanium Dioxide, Methylcellulose, Does NOT contain MI ((methylisothiazolinone) or any type of VOC.

MAL code 00-1